(as of Apr 23,2020 04:52:53 UTC – Details)
10 × Bottom screws
4 × Bottom out & inner foot
1 × Screwdriver
1.Do not wipe the glue.use the cotton dry swab to absorb any excess glue. Fumes from other types of glue could affect other internal components.Excess puddled glue may take hours to dry and may cause the bottom case to adhere to the logic board or interior cabling.
2.Screws at sides and front must be removed and installed at an angle.
3.wftcInstall screws in order shown. If sequence is not followed, bottom case might wobble when placed on level surface.
SAFETY INSTRUCTIONS-GLUE IS AN EYE AND SKIN IRRITANT.
GLUE BONDS TO SKIN INSTANTLY.
Contains ethyl cyanoacrylate. Avoid contact with skin and eyes. If eye or mouth contact occurs, hold eyelid or mouth open and rinse thoroughly but gently with water only for 15 minutes and GET MEDICAL ATTENTION. Liquid glue will sting eye temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor.
If skin bonding occurs, soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may cause skin burn. If spilled on clothing, flush with cold water. Avoid prolonged breathing of vapors. use with adequate ventilation. KEEP OUT OF THE REACH OF CHILDREN.
1.A MacBook Pro covered by the Apple Limited Warranty or by an AppleCare Protection Plan may receive a replacement foot without charge.
2.A MacBook Pro that is out-of-warranty may have a charge associated with the replacement.
3.The DIY replacement kit not available for MacBook Pro with Retina display computers.
Compatible with Unibody Apple Macbook Pro A1278 A1286 13″ 15″ 17″ bottom Case(not for retina display)
Can be applied for macbook pro in 13 inches, 15 inches and 17 inches (not for retina display)
3 Long and 7 short bottom screws set can be a replacement for your Macbook Pro
Case foot is made of rubber and plastic, durable